PT - JOURNAL ARTICLE AU - Marx, D A AU - Slonim, A D TI - Assessing patient safety risk before the injury occurs: an introduction to sociotechnical probabilistic risk modelling in health care AID - 10.1136/qhc.12.suppl_2.ii33 DP - 2003 Dec 01 TA - Quality and Safety in Health Care PG - ii33--ii38 VI - 12 IP - suppl 2 4099 - http://qualitysafety.bmj.com/content/12/suppl_2/ii33.short 4100 - http://qualitysafety.bmj.com/content/12/suppl_2/ii33.full SO - Qual Saf Health Care2003 Dec 01; 12 AB - Since 1 July 2001 the Joint Commission on Accreditation of Healthcare Organizations (JCAHO) has required each accredited hospital to conduct at least one proactive risk assessment annually. Failure modes and effects analysis (FMEA) was recommended as one tool for conducting this task. This paper examines the limitations of FMEA and introduces a second tool used by the aviation and nuclear industries to examine low frequency, high impact events in complex systems. The adapted tool, known as sociotechnical probabilistic risk assessment (ST-PRA), provides an alternative for proactively identifying, prioritizing, and mitigating patient safety risk. The uniqueness of ST-PRA is its ability to model combinations of equipment failures, human error, at risk behavioral norms, and recovery opportunities through the use of fault trees. While ST-PRA is a complex, high end risk modelling tool, it provides an opportunity to visualize system risk in a manner that is not possible through FMEA.